Sorensen DLM32-125E

The Sorensen DLM 3 kW and 4 kW Series programmable DC power supplies are designed to provide highly stable, continuously variable output voltage and current for a broad range of applications in a compact 2U ( 3½" high) chassis.

The 4 kW power rating is new to the Sorensen Family of power supplies. The output RMS noise is as low as 10 mV. The output will recover to 1% of its steady-state voltage within 1 ms for a step load change of 100% to 70% or 70% to 100%. The front panel layout makes the series extremely easy to use. Control switches include: power on, enable/ standby and local/remote.

Displays and indicators show programmed set points and operational control status. The programmed voltage, current and overvoltage set points are displayed with two large 3½ digit LED displays. Operational Status LEDs indicate power on, shutdown, overtemperature, overvoltage, constant current and voltage mode status. Control Status LEDs indicate front panel lockout, remote control and standby status. IEEE-488.2 control LEDs indicate error, service request and remote address status.

Option M2 Requires 432-528 VAC Input Power, 47-63 Hz, three phase, 3 wire plus ground, Delta or WYE may be used

High Power Density 2U (3½ inches) high, 19 inches wide; no top or bottom clearance spacing required

Preview Pushbutton
Overvoltage protection (OVP), voltage and current preview buttons allow viewing these set points at any time with or without the output enabled

Remote Voltage Sense
Sense leads are easily connected to a solderless connector

Remote Operation
- Standard analog programming
- Output enable/disable remotely
- Optional IEEE-488.2 and RS 232
- Optional optically isolated analog programming

Calibration
All models can be calibrated without removing the covers

Operating Modes
Constant voltage and constant current, with LED indicators

Parallel or Series Operation
Field configurable

Input Power Factor
0.95 typical (three phase for all models) 0.98 typical (single phase)