Requires 440-480VAC, 47-63Hz, three phase input power
The DHP family provides models ranging in output power from 5 kW to 20 kW in a single chassis. Programmable output voltages range from 5V to 50 VDC, delivering up to 3,000 amperes. This family has two operational modes, constant-voltage and constant-current.
The DHP family uses control technology that allows 9 auto sequence steps, each step can be up to 99,999 seconds in duration. Combining all the steps allows a maximum auto-step program 27.7 hours long. Various voltages, currents and durations can be programmed for each step.
Unique Controls and Commands
Power-Off Memory: Enabling the input power and pushing the LAST SET button will restore the supply settings
External Shutdown: An external shut down to inhibit the output
Up/down arrows control voltages, step changes and current
Digital Displays
Power supply rating
Output power, voltage and current
All power, voltage and current set points and limits
Present and highest AC input voltage
Present and highest air inlet temperature
Power and auto-step sequence settings
Calibration set-up
Remote operation set-up
Diagnostics fault status summary
Protection and Safety
Safe Power-Up: In the local mode, the output is disabled for additional safety at power up
Front Panel Lockout: Most front panel controls are disabled when operated remotely
Overvoltage, over-temperature, surge limit, soft start, brown out and short circuit protection current limit fold back.
Operation Manual
25 Pin Connector (installed)
AC Input Cover (installed)
Output Cover (installed)
