Sentry 30 Plus - AC/DC/IR Hipot Tester

The Sentry 30 Plus AC/DC/IR Hipot Tester (CE Mark) has all of the features of the Sentry 20 Plus in addition to Insulation Resistance (IR) testing. The IR measurement range is from 0.1MΩ to 50GΩ with test voltages from 50 to 1000VDC.

Program & Display Ground Continuity: The Sentry Plus Series can measure and display the resistance between the ground blade of the power cord and any exposed metal on the product.

Meets UL Hipot Tester Requirements: The Sentry Plus instruments measure & display the output voltage directly at the output terminals. The instruments have both visual and audible failure indications, and after a failure the STOP switch must be pressed prior to another measurement

Key Features:

• AC Hipot Voltage 50 to 5000V, Output Current to 20mA
• DC Hipot Voltage 50 to 6000V, Output Current to 5mA
• IR Measurements 100kohms to 50Gohms, Test Voltage 50 to 1000VDC
• Programmable Ground Continuity Check, 0.1 to 5ohms
• Programmable Ramp, Test, and Fall Times
• Fast Cutoff and Discharge of Device Under Test
• Programmable Hi/Lo Limits for Pass/Fail Testing
• Large LCD Display for Menu Programming and Test Results
• Internal Storage and Recall of 80 Test Setups
• Ground Fault Interrupt Shutdown for Operator Safety
• Front and Rear Panel Output Connections
• Front Panel Lockout Prevents Changes to the Test Setup
• Automatic Offset to Zero Out Stray Leakage Current
• Instruments Upgradeable, Sentry 10 to 20 to 30
• 3mA Current Limit per EN50191
• UL Listed and CE Marked