Fluke TN2100

The CopperPro family of loop testers from Fluke Networks packs a full complement of test and troubleshooting capabilities into one rugged, integrated tool for OSP technicians. 

Now we've expanded its capabilities even further with Terminator -

 an accessory module to the 990DSL CopperPro that lets you perform terminated transmission testing Quickly, Easily, Single-handedly.

Together, the CopperPro and Terminator are a major advance in qualifying and troubleshooting copper access network circuits, including HDSL2/4. Nothing else on the market offers a more complete and effective solution for reducing failure frequency, repeats, and chronic problems with special services circuits.

13 Testing Advantages

• Loop terminations and VF / WB single tones for testing on either of two pairs (Pair 1 and 2)
• Bridging / splitting access between Pair 1 and Pair 3 (CO Pair
• Composite VF and WB tones for greatly increased testing speed
• DTMF signaling control on both Pair 1 and Pair 2 (Pair 1 alone, if powered down)
• Signaling and testing on the same pair (either Pair 1 or 2)
• Extremely low-power mode when turned off
• DTMF transceiver switchable via relay to either Pair 1 (default) or Pair 2, or removed from both for a preset time interval whenever its input impedance would affect the 990 CopperPro measurement from the far end (i.e., shorts and grounds, or opens)
• Operable from a standard butt-set, when line powering is present (i.e., idle POTS line)
• DTMF command protocol allows for "Ack / Nack" closed-loop feedback response to control commands, increasing reliability
• Tracing Tone mode (TR metallic 577 Hz signal)
• Powered by a standard, off-the-shelf 9 VDC Alkaline non-rechargeable battery
• Battery cover removable without the use of a tool
• Operates from an external 12-15 VDC power source, such as the AC and DC power cords provided with the 990 CopperPro, automatically disconnecting the internal battery when plugged in