5 in/lb to 250 ft/lb Digital Torque Calibration System
The CDI Digitest is a 5 in/lb to 250 ft/lb Digital Torque Calibration System with accuracy of 0.25 percent of indicated value. The Digitest is comprised of the 950DT Indicator, TTPM-41 4-in-1 Transducer, and the 250L-1 Mechanical Loader.
The 950DT Digitest system indicator allows easy selection of 7 torque units (ft-lb, in-lb, in-oz, Nm, dNm, cNm, mkg), and is designed to operate in either manual or power tool modes.
The TTPM-41 4-in-1 Transducer covers the entire range of 5 in/lbs to 250 ft/lbs in 1 transducer package.
The 250L-1 Mechanical Loader provides a stop that holds the torque wrench handle in a fixed position and rotates the transducer under the wrench drive. The system applies a precise, monitored torque to the wrench up to 250 ft/lbs.
Power Tool Testing - A joint rate simulator is required when testing a power tool to allow start-up rotation of the tool’s armature. The simulator is experimentally adjusted to replicate the average joint hardness of the intended work.
Features:
- Closed Case Calibration
- Easy Selection of 7 Different Torque Units
- Accuracy 0.25% of Indicated Value
- Modes: Peak / First Peak / Track / Power Tool
- Battery Power or Line Voltage for Portable Operation
Specifications:
- Digitally calibrates all torque tools including power tools
- Accuracy better than .25% indicated value (10-100% of transducer range)
- Full easy-to-read alphanumeric display
- Automatic sensing of active transducer by internal coding
- RS232C port standard
- Easy selection of 7 different torque units
- Sealed chemical resistant membrane keypad
- Quick and easy calibration from front keypad
- Durable high impact case with reinforced ball handle
- Complete digital microprocessor based circuitry
- Superfast Power Tool mode to be used with joint simulator (Pulse type air tools not recommended)
- Peak mode both clockwise and counterclockwise
- First peak mode for "click" and clutch type tools
- Track mode
- Super twist LCD display - view at any angle
- Easy calibration mode with instructions via alphanumeric display
- Bail handle and two 9- volt batteries makes unit portable
- Match with any Digitest torque transducer
- Lightweight - only 3.5 lbs.
- Accepts any load cell output at 2 or 3 mv/v.
- AC power for standard 110/120 volt
Please contact our sales department for more information.
